Pages: [1]   Go Down
Author Topic: LED on pin 13 broken? how to test?  (Read 241 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 14
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi,

I just realized that pin13 LED on my UNO is not responding. The sketch, I was running, was a simple sensortest, connected to A0 and blinking P13 if the sensor switches.

It looks like it is only the LED, because toggeling p13 shows 5V on voltmeter.

But how can it be , that only the LED is broken? And why? Can I change it?

It is possible to use an external LED, but I like this feature so much smiley

thank you for helping
« Last Edit: June 25, 2013, 07:13:00 am by Samond » Logged

Austin, TX
Offline Offline
Faraday Member
**
Karma: 64
Posts: 6055
Baldengineer
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Did you remember to set the pin to OUTPUT?
Logged

Capacitor Expert By Day, Enginerd by night.  ||  Personal Blog: www.baldengineer.com  || Electronics Tutorials for Beginners:  www.addohms.com

Global Moderator
Offline Offline
Brattain Member
*****
Karma: 452
Posts: 18694
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

The sketch, I was running ...

What sketch?


How to use this forum
Logged

Pages: [1]   Go Up
Jump to: