Go Down

Topic: Arduino 2560Mega not responding to code (Read 382 times) previous topic - next topic

clubman

Hello guys,

I have recently purchased an Arduino 2560 Mega from ebay and I am trying the Blink tutorial with different delay times but the LED always blinks by 1secON-1sec OFF. It doesn't respond to code changes.

I also noticed that Funduino is written on the board. i'm using the standard Adruino environment to program it. Should I do something else?

Please help!
Thanks!

CrossRoads

Under FIle:Preferences, check the Verbose output boxes.
What output do you get when you upload?
Designing & building electrical circuits for over 25 years.  Screw Shield for Mega/Due/Uno,  Bobuino with ATMega1284P, & other '328P & '1284P creations & offerings at  my website.

clubman

Thanks, I am back!

What I get is the following:

avrdude: Version 5.11, compiled on Sep  2 2011 at 19:38:36
         Copyright (c) 2000-2005 Brian Dean, http://www.bdmicro.com/
         Copyright (c) 2007-2009 Joerg Wunsch

         System wide configuration file is "C:\Program Files (x86)\Arduino\hardware/tools/avr/etc/avrdude.conf"

         Using Port                    : \\.\COM9
         Using Programmer              : arduino
         Overriding Baud Rate          : 115200
avrdude: Send: 0 [30]   [20]
avrdude: Send: 0 [30]   [20]
avrdude: Send: 0 [30]   [20]
avrdude: Recv:
avrdude: stk500_getsync(): not in sync: resp=0x00

avrdude done.  Thank you.


How should I proceed?

Thank you

clubman

Supernoob here! Doooh..

Chose the correct board and thats it.. Many many thanks CrossRoads!!!!

Go Up