Go Down

Topic: Arduino 2560Mega not responding to code (Read 421 times) previous topic - next topic

clubman

Hello guys,

I have recently purchased an Arduino 2560 Mega from ebay and I am trying the Blink tutorial with different delay times but the LED always blinks by 1secON-1sec OFF. It doesn't respond to code changes.

I also noticed that Funduino is written on the board. i'm using the standard Adruino environment to program it. Should I do something else?

Please help!
Thanks!

CrossRoads

Under FIle:Preferences, check the Verbose output boxes.
What output do you get when you upload?
Designing & building electrical circuits for over 25 years.  Screw Shield for Mega/Due/Uno,  Bobuino with ATMega1284P, & other '328P & '1284P creations & offerings at  my website.

clubman

Thanks, I am back!

What I get is the following:

avrdude: Version 5.11, compiled on Sep  2 2011 at 19:38:36
         Copyright (c) 2000-2005 Brian Dean, http://www.bdmicro.com/
         Copyright (c) 2007-2009 Joerg Wunsch

         System wide configuration file is "C:\Program Files (x86)\Arduino\hardware/tools/avr/etc/avrdude.conf"

         Using Port                    : \\.\COM9
         Using Programmer              : arduino
         Overriding Baud Rate          : 115200
avrdude: Send: 0 [30]   [20]
avrdude: Send: 0 [30]   [20]
avrdude: Send: 0 [30]   [20]
avrdude: Recv:
avrdude: stk500_getsync(): not in sync: resp=0x00

avrdude done.  Thank you.


How should I proceed?

Thank you

clubman

Supernoob here! Doooh..

Chose the correct board and thats it.. Many many thanks CrossRoads!!!!

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy