> successfully bootloaded them with the Uno bootloader,> For the board, I've tried Uno, Duemilanove w/ 328P, Duemilanove w/ 328, basically any that has the Atmega328 labeled.Only the UNO choice will work because the UNO bootloader uses a different baud rate from the earlier boards.> have wired it so that it provides 5V and Ground via USB and the programmers' Tx is connected to> pin0 and the Rx to pin1, as I've read in the tutorial.Since you don't have DTR connected through a capacitor to Reset you will have to do a manual reset. Hold down the Reset button down, click on the sketch's upload button, and when you see the "Binary sketch size:" message appear, release the Reset button.
Nowhere have I read about the DTR pin, how large of a capacitor value should I use to between the DTR and the reset? Would 0,1uF be ok?
But now I'm concerned a bit about the different baud rate, could the Uno be set up to work at 31250 baud? I need it to send MIDI data amongst other things. Thank you so much for everything!
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16