next topic »

[on:]

It was a bit hard to pick a forum to post this in so I picked this one. (Moderators, If its the wrong one please move me to the correct one.)

I am looking for companies that can supply custom made cables that look like these:

I have designing an Arduino CNC Shield and it needs a bunch of these cables to connect end-stops. (Need to be 100cm long as well)
http://blog.protoneer.co.nz/arduino-cnc-shield/




Not sure what you call these as the ones I have found are called jumper wires or Dupont connectors (2.54mm pitch).

Any help will be appreciated.

[Reply #1 on:]

I am looking for companies that can supply custom made cables that look like these:

What's special about them? Why can't you just buy them on ebay like everybody else?

[Reply #2 on:]

What's special about them? Why can't you just buy them on ebay like everybody else?

The longest I could find on ebay was 30cm and those would not be long enough to reach all the ends on a small cnc router.

I bought a Ramps 1.4 3d printers board the other day and that came with 100cm cables that worked really well.

[Reply #3 on:]

What's special about them? Why can't you just buy them on ebay like everybody else?

The longest I could find on ebay was 30cm and those would not be long enough to reach all the ends on a small cnc router.

http://www.ebay.com/itm/321020831563

[Reply #4 on:]

http://www.ebay.com/itm/321020831563

Well spotted... thanks for that. They also have some 4 pin 100cm cables that will be perfect for stepper motors.