Go Down

Topic: Wire Manufacturer / Supplier (Read 3 times) previous topic - next topic

Protoneer

It was a bit hard to pick a forum to post this in so I picked this one. (Moderators, If its the wrong one please move me to the correct one.)

I am looking for companies that can supply custom made cables that look like these:


I have designing an Arduino CNC Shield and it needs a bunch of these cables to connect end-stops. (Need to be 100cm long as well)
http://blog.protoneer.co.nz/arduino-cnc-shield/




Not sure what you call these as the ones I have found are called jumper wires or Dupont connectors (2.54mm pitch).

Any help will be appreciated.

fungus


I am looking for companies that can supply custom made cables that look like these:


What's special about them? Why can't you just buy them on ebay like everybody else?

No, I don't answer questions sent in private messages (but I do accept thank-you notes...)

Protoneer


What's special about them? Why can't you just buy them on ebay like everybody else?


The longest I could find on ebay was 30cm and those would not be long enough to reach all the ends on a small cnc router.

I bought a Ramps 1.4 3d printers board the other day and that came with 100cm cables that worked really well.

fungus



What's special about them? Why can't you just buy them on ebay like everybody else?


The longest I could find on ebay was 30cm and those would not be long enough to reach all the ends on a small cnc router.



http://www.ebay.com/itm/321020831563
No, I don't answer questions sent in private messages (but I do accept thank-you notes...)

Protoneer


http://www.ebay.com/itm/321020831563


Well spotted... thanks for that. They also have some 4 pin 100cm cables that will be perfect for stepper motors.

Go Up