Go Down

Topic: ADXL335 vs.BMA180 for calibration (Read 317 times) previous topic - next topic

melnarte

I have the problem with "Voltage to g" conversion for ADXL335.

Like reference device I use BMA180 Digital Accelerometer fixed in the same object and same axis orientation like ADXL 335 (see pict.''ADXL335vsBMA180.jpg'').

I receive a courbes and I see that initial g value of digital sensor not correspond to recalculated from tension g value of analog sensor

figure untitled_x.jpg shows that initial static value is not correct.
figure untitled_y depicts  that initial static  and dymamical values are not correct.
figure untitled_z seems correct.

Any ideas ?

Sincerely yours

ISR_lab_Donetsk
Artem

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy