Go Down

Topic: LVTTL GPS Module Communicating with Arduino MEGA (Read 772 times) previous topic - next topic

Hellmaaf

Hello all!

I'm keen to get a gps module talking to my Arduino Mega.

I have been recommended 65 Channel SUP500F 10Hz GPS Receiver with Smart Antenna  as a good one to go with.

I noticed however in the datasheet (  .sparkfun.com/datasheets/GPS/Modules/SUP500F_v3.pd )

that it is LVTTL, what (if anything) is required to set this up to work with the Mega hardware serial ports which I believe are TTL?

Looking forward to hearing from some people with a bit more experience than I!

H  :)

Hellmaaf

So I found this thread:

http://www.arduino.cc/cgi-bin/yabb2/YaBB.pl?num=1273151381/0

Which seems to partially answer my question... any elaboration on the topic would be appreciated though!

Speak up people! :)


Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy