Go Down

Topic: Interfacing BCM2040KFB bt module with arduno (Read 393 times) previous topic - next topic

^Mr.Rat^

May 22, 2010, 12:44 pm Last Edit: May 22, 2010, 12:48 pm by flokos Reason: 1
I have a Broadcom BCM204049KFB bluetooth module on an acer ferrari 4000 mouse and i realised that it has 4 pins ,1 for tx ,one for rx ,one for vcc and one for gnd.Then i soldered on them 4 female headers and i tried to connect it with my arduino but i realised that when i put all the wires on the headers the mouse does not work but when i put only the tr,gnd and vcc it works.So i did this post to see if anyone can help get this module work with my arduino .
This is a foto of the mouse

Go Up
 

Quick Reply

With Quick-Reply you can write a post when viewing a topic without loading a new page. You can still use bulletin board code and smileys as you would in a normal post.

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.
Name:
Email:

shortcuts: alt+s submit/post or alt+p preview