Go Down

Topic: Esplora won't upload (Read 3 times) previous topic - next topic

fusion44

I got an esplora recently, and after much hassle with drivers, managed to upload some sketches with a windows 7 laptop.
Today, I pulled it out, and tried to upload a sketch with a laptop running 64-bit fedora 17
I got this in my verbose output:
Code: [Select]

avrdude: Send: S [53]
avrdude: ser_recv(): programmer is not responding
avrdude: butterfly_recv(): programmer is not responding

I also tried again with the windows laptop. Sometimes I got the same error, sometimes arduino couldn't find the Esplora.

Nick Gammon

I think the Esplora is one of those boards where you have to hold down Reset and let go the moment you start uploading the sketch.
http://www.gammon.com.au/electronics

fusion44

It didn't seem to work. I got the same verbose output.

Nick Gammon

Sometimes I have to try two or three times with my Leonardo, which has the same chip. You let go of Reset when it says "uploading". Timing can be quite tight.
http://www.gammon.com.au/electronics

fusion44


fusion44

Nevermind, it was a faulty cable. It works now.

Go Up