Pages: [1]   Go Down
Author Topic: Due Analog Current Draw  (Read 463 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 3
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I am trying to figure out what the current draw is of one of the analog pins on the due board. The resistance would me appreciated as well. I am working with high and low pass filters in this area of my circuit and am worried about possible signal strength and filter accuracy. Thank you.
Logged

White River Junction, Vermont USA
Offline Offline
Full Member
***
Karma: 5
Posts: 106
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Assuming you mean analog inputs (ADC):

See section 46.7 of the SAM3X datasheet for some good info.

I think what you're after is Table 46-36, page 1420 (Attached).

-Chris


* Capture.PNG (13 KB, 579x171 - viewed 36 times.)
Logged

Pages: [1]   Go Up
Jump to: