Go Down

Topic: Nunchuk Eagle (Read 1 time) previous topic - next topic


May 06, 2013, 02:10 am Last Edit: May 08, 2013, 04:29 am by Paulware Reason: 1
 There was a nunchuk eagle topic started a couple years ago but it was not answered and is now closed.
 I also would like to make a nunchuk adapter in eagle.  I know they are available at sparkfun.
 The nunchuk adapter is basically 4 connectors.  2 on the top and 2 on the bottom.
 They are .15 inches apart ( I think) and are about roughly .1 inches wide.
 The top is ground and SCL and the bottom is power and SDA.   I can wire the items in eagle.  But I don't know how to create pads that occupy the same area but on the top is one pad and on the bottom is a different pad.

 Meanwhile...2 days later....I found some helpful links including a schematic that has 2 nunchuk breakouts:


Schematic and board are referenced here:

alternate writeup:

alternate writeup:


Created this dual nunchuk tindie project: https://www.tindie.com/products/Paulware/dual-nunchuk-shield/

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131