Go Down

Topic: mounting potentionmeters (Read 638 times) previous topic - next topic

pluggy

Hot melt glue is good assuming the part in question doesn't get hot.  It sticks pretty good to plastic project boxes and stripboard / pcbs and can usually be convinced to let go if the worst comes to the worst.  Its cheap assuming you already have a glue gun.  :)

idlethreat

You guys are nine kinds of awesome. Thanks for all the input.

I think I'll go ahead with the perf-board-and-standoffs route to get this project put to bed. I'll definitely make a point of going with panel mount pots in subsequent projects, so I don't have to run into this particular issue again.

Thanks again for all the good ideas,

idle

Go Up