Go Down

Topic: Wireless Shield for Xbee + Ethernet Shield R3 + Arduino Mega 2560 R3 (Read 1 time) previous topic - next topic

prab3

Hello Everyone,

I am new to arduino and would like your guys input for the following equipment I will be using for my project. Is it possible to stack the following items given below on top of each other? Thanks for reading!

Arduino Mega: http://www.amazon.com/Arduino-MEGA-2560-R3/dp/B006H0DWZW/ref=sr_sp-atf_title_1_1?ie=UTF8&qid=1375645951&sr=8-1&keywords=arduino+mega

Arduino Ethernet Shield R3: http://www.amazon.com/Arduino-Ethernet-Shield-R3/dp/B006UT97FE/ref=sr_sp-atf_image_1_1?ie=UTF8&qid=1375644506&sr=8-1&keywords=arduino+ethernet+shield

Arduino Wireless Shield: http://www.amazon.com/Arduino-Wireless-Shield/dp/B007QXRA4I/ref=sr_1_4?ie=UTF8&qid=1375572807&sr=8-4&keywords=xbee+shield


btfdev

Surprise that no one able to answer this!

Running into similar plan and wonder if we can stack

Arduino Uno + Ethernet + Wireless shield for Xbee.

Any thoughts?

Team BTF.

btfdev

Well, after some quick look up and I might have the answer folks !!!

If you use an UNO, Ethernet shield uses PIN 11, 12 and 13
If you use a Mega, Ethernet shield uses PIN 50, 51 and 52

Now stack the Wireless SD shield on top

Arduino TX(1) and RX(0) will be used for xbee
SDcard on Ethernet & Wireless SD can not be used.

Rest of the pins are all available. Hope we are correct.

Team BTF

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy