Go Down

Topic: Ultrasound module (Read 844 times) previous topic - next topic


I have an ultrasound module that I need to use (not buying another) and was wondering if there is a way of using it with Arduino. No problem if not, as it has its own board and uses a serial connection.

Here is the datasheet:

It comes with its own board to drive it, and timing, then sends as serial message.

My only thought for linking into Arduino, is that I'm using the serial port for a touch screen and wondering if there would be a conflict (and the need to add an extra serial port pci card)


Sep 28, 2006, 01:52 am Last Edit: Sep 28, 2006, 01:52 am by CasNet Reason: 1
Yes, that should work quite nicely. They aren't very clear on whether it uses RS-232 voltages, which may require a simple interface, but if it connects directly to a stamp, it should be fine.

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131