Pages: [1]   Go Down
Author Topic: Cant turn on grid in Eagle for Arduino Proto_shield.brd  (Read 2639 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Newbie
*
Karma: 1
Posts: 30
Old EE learning new tricks.
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I downloaded http://arduino.cc/en/uploads/Main/arduino_ProtoShield_Rev3.zip as a starting point for my first shield (my first project in fact) and while I can turn on the grid in the Schematic View, no matter what I try, the grid won't appear in the Board view and the components won't snap.

If I create a new Board, everything works fine. What am I missing?
Logged

SF Bay Area (USA)
Offline Offline
Tesla Member
***
Karma: 135
Posts: 6765
Strongly opinionated, but not official!
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

The grid on that board is currently set at .127mm; too fine to display, or notice a "snap."
Do you still have a problem if you reset the grid to the default (1.27mm)? (It works fine for me!)
Logged

Pages: [1]   Go Up
Jump to: