Pages: [1]   Go Down
Author Topic: designing shield  (Read 1620 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Newbie
*
Karma: 0
Posts: 19
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

while designing shield for rc servo motor  with 5v voltage regulator we are facing following problem

there are 3 pins for rc servo motor . first for signal ,second for supply and third for ground.
input voltage is 7v dc . whitout connecting to arduino we are getting .2v to .7v  at pin no one. what is exact problem
Logged

Global Moderator
Netherlands
Offline Offline
Shannon Member
*****
Karma: 227
Posts: 14024
In theory there is no difference between theory and practice, however in practice there are many...
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Please post your schematics so we can find out
Logged

Rob Tillaart

Nederlandse sectie - http://arduino.cc/forum/index.php/board,77.0.html -
(Please do not PM for private consultancy)

Pages: [1]   Go Up
Jump to: