Pages: [1]   Go Down
Author Topic: Motor Control Im Stuck...  (Read 274 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 1
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi there,

It has been a while even my login on arduino forum was gone :S but i need some help from you guys im stuck with my motor control for my remote control underwater robot. I Use 8x a N-Ch (200w) mosfet for controling the motor (24v 6A 120W) Controled by Arduino (I luv this chip).

If i conect 12v and say i give the max current of 0.400A and i pullup the Gates HIGH the output out of the mosfets is 0.40 volts and the current that its is using then is around the 0.200A and i used a volt meter to test the output so somthing is using a amount of mA. :-S and im burning my transistors out. I dont know what to do. Im lost smiley-sad Please help?

Im using a Atmege168-20PU in this project (Several)
The Setup is a N-Channel H Bridge.
Mosfets i use: IRFS31N20DTRL (Also tried with the IRF730 same result)

I Hope you can tell me what im doing wrong?!

Thanks,

Christian
The Netherlands


* mains_motors.jpg (261.63 KB, 1647x463 - viewed 15 times.)

* mosfet_driver.jpg (93.22 KB, 593x443 - viewed 12 times.)
« Last Edit: September 30, 2013, 05:42:27 am by BRQ4 » Logged

Pages: [1]   Go Up
Jump to: