Go Down

Topic: Arduino Uno Motor Shield (Read 510 times) previous topic - next topic


I have been trying to drive two motors separately using Arduino Uno and the new Arduino Uno motor shield with Flowol software but I can only get one motor to turn, it is the one connected to 1A and 1B, there is no voltage at 2A and 2B irrespective of how I program the Uno.
The Flowol software has detected the motors when it is connected to the Arduino.

Is my motor shield faulty?
Is this a problem with the software?
This is my first attempt at using an Arduino so any help/suggestions gratefully accepted.


Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131