Go Down

Topic: Use of Arduino shield off the Arduino (Read 1 time) previous topic - next topic

A2AROV_6

Would it be possible to utilize  an Arduino Motor Shield V3 without actually stacking it on top of the Arduino Uno?  I am wanting to use multiple shields.  Is the only way to make them all work, stacking them?

element74

No, you could connect it with jumper wires. Multiple shields could be used this way. Why do you not want to stack them?

CrossRoads

Unstacking allows more flexibility in where the control signals go.
2 identical boards cannot be stacked if they do not allow for different control signal selection.
Designing & building electrical circuits for over 25 years. Check out the ATMega1284P based Bobuino and other '328P & '1284P creations & offerings at  www.crossroadsfencing.com/BobuinoRev17.
Arduino for Teens available at Amazon.com.

A2AROV_6

I am wanting to use multiple motor shields to control multiple motors.   And use a proto shield on each to keep it all clean.

Go Up