Go Down

Topic: Touch sensor probs (Read 422 times) previous topic - next topic

Barte

First of all, I'm a total electronic newbie.

I got the arduino board and a tocuh sensor : mpx200d from Motorola.
It has 4 pins,
1) GND
2)+V out
3) Vs
4) -V out

And I don't have a clue what that means :)
what pin should I wire to witch part of my arduino board? And also, what resistor do I need? And should I use 9V or 5V?

I'm kind of desperate. Please help.
Help is much appreciated.

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy