Go Down

Topic: Can't get readings on BMP085 using Arduino Uno R3 (Read 477 times) previous topic - next topic


Hi all,

I am trying to set-up my Arduino Uno R3 with my Bosch BMP085 pressure sensor. But I can't seem to attain any readings in serial monitor. All I get on my arduino serial monitor is:

Setting up BMP085
Reading Calibration Data

Hope someone can help me out here.

Thank you!


Nov 10, 2013, 06:23 pm Last Edit: Nov 10, 2013, 06:25 pm by antknight Reason: 1
Try this code here, worked for me!
Unzip into arduino\libraries folder.
An example included.


Hey antknight!

Thank you very much. Its up and running!

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131