Pages: [1]   Go Down
Author Topic: 4.3" TFT LCD Touch Screen and Arduino Mega  (Read 969 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi everyone,
Simply i want to draw a picture to my tft lcd touch screen. I bought 4.3" TFT LCD Touch Screen with SD card support. And for the connector/resistor PCB i bought ElecFreaks's TFT LCD Mega Shield v2.2 and i have arduino mega 2560. I found a sample code in Arduino IDE. But it's not working. I think it's about the pin definition. I couldn't find anything about this situation. Program was compiled succesfully and uploaded successfully but at the Serial Monitor loggin this. " Initializing SD card... failed! "
The sample code check out the on Arduino IDE > TFT > Arduino > TFTBitmapLogo.

Thanks...
Logged

0
Offline Offline
Shannon Member
****
Karma: 207
Posts: 12200
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Was there an SDcard in the slot?  If not then initializing an SDcard will definitely fail.
Logged

[ I won't respond to messages, use the forum please ]

Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Yes, Of course. I formatted sd card with fat system. It's 8 GB.
Any idea?
Logged

0
Offline Offline
Shannon Member
****
Karma: 207
Posts: 12200
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

There is more than one SD library to experiment with, but first check all the signals are
intact and at 3.3V level.  These TFT/SD modules never seem to have level-shifting on the
SDcard.
Logged

[ I won't respond to messages, use the forum please ]

Pages: [1]   Go Up
Jump to: