Pages: [1]   Go Down
Author Topic: Burning bootloader to atmega8 using arduino UNO (v3)  (Read 336 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Jr. Member
**
Karma: 0
Posts: 69
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

i bought an atmega8 from the shop(its totally blank)
i want to write some arduino codes in that.
how do i do it?
(i have made the circuit using 2 capacitors and a 16mhz crystal. )
Logged

Atlanta, USA
Offline Offline
Edison Member
*
Karma: 53
Posts: 1794
AKA: Ray Burne
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Start here:
http://arduino.cc/en/Hacking/Bootloader?from=Main.Bootloader

You will use the Arduino UNO as an ISP programmer, sketch ArduinoISP

You will need the bootloader code for the Atmega8 ...  try this reference:
http://arduino.cc/en/Hacking/Bootloader

Here is a good overview:
http://www.gammon.com.au/forum/?id=11637

Good luck.  You may need to do some googlin' to fill in your knowledge.


Ray
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 5
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

You can try using optiLoader.
https://github.com/WestfW/OptiLoader
And here's a guide on how to do it
http://3g1l.com/blog-burn-bootloader-blank-atmega328atmega328p-arduino-uno
Logged

Pages: [1]   Go Up
Jump to: