Pages: [1]   Go Down
Author Topic: RFID RC522 ... Help required  (Read 318 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 18
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I want to install RFID system as a car Security system. The PCB has on built coil and works fine with 5 leads attached to Arduino. Due to its bigger size, i cant place it in the required position. I have therefore decided to cut the coil part of PCB to make the coil small and place it in the required area.

1. Can I do that or Can I connect any external coil with it ?
2. How to reduce the no. of pins to max 2 or 3.

Thanks

Logged

Manchester (England England)
Offline Offline
Brattain Member
*****
Karma: 596
Posts: 33288
Solder is electric glue
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

1) no not without designing a replacement coil that resonates at the same frequency. To do that you need test equipment an oscilloscope and signal generator are the minimum.

2) no.

Note an RFID is not normally any use close to metal like the car's bodywork.
Logged

Pages: [1]   Go Up
Jump to: