I'm new to microcontrollers, and have been using the Arduino for a couple of weeks now. I would like to develop my projects using the Arduino IDE, and board, then remove the programmed chip and place it into a circuit board/breadboard.I think I've got most of this figured out, but I want to keep my component count low. So how do you run the chip without an external clock? I tried the ATMega datasheet, but I'm afraid I don't know enough about AVR programming to make sense of it. I think I have to set some fuses for this, but I haven't a clue on how to do that.My projects are mostly LED based, (no motors, solenoids, etc..)Any advice and sample code would be greatly appreciated!
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16