I looked for a list of KS0108 equivalents but couldn't find one. Do you know if the Epson SED1335F is compatible?
Hello i am new to Arduino i make an Adilson's serial Arduino with Atmega 8 mcu i am using the KS0108 library but i cant get any result in LCD. Did it work only Atmega168 board or not. If i try to upload sketch with LCD connected i get an error message. If i remove the LCD from the board it uploads the sketch but no result.
I've tried this on a graphic LCD I got from here: http://futurlec.com/LED/BLUE128X64LCD.shtml with no luck.It's a "B" style pinout, and although the LCD lights up and I get contrast adjustment, I get no actual graphics from the Arduino. I do get a slight flicker running down the screen with a medium contrast, but that's it. I've triple checked the wiring - the only thing I'm not sure of is the resistor to the backlight, but it's 180 Ohm (in the middle of the range given), and I can't see how that would affect data. Any clues? I'm using a diecimila with Arduino v0010.Thanks! jai..
QuoteI've tried this on a graphic LCD I got from here: http://futurlec.com/LED/BLUE128X64LCD.shtml with no luck....Hi jai,Try adding the following line to the ks0108.h file #define PUBLISHJust before the line#ifndef PUBLISHdelete the ks0108.o file and recompile your sketch.
I've tried this on a graphic LCD I got from here: http://futurlec.com/LED/BLUE128X64LCD.shtml with no luck....
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16