Go Down

Topic: Unmanned Quad Copter Project (Read 2453 times) previous topic - next topic

Hi all,

I'm currently working on a project where I am making a quadcopter.  This copter only needs to be able to lift off the ground for a few seconds and then set down safely.  I am currently using a Chip Kit Max32 and will be controlling the 4 motors with a motor driver.  What is the easiest way I can program this and set it up to give me my desired results?  Thanks a lot for all your help.

PaulS

Quote
What is the easiest way I can program this and set it up to give me my desired results?

Perhaps your local Ford dealer could help. Why would you ask questions about some non-Arduino board here?

Nick Gammon

Please post technical questions on the forum, not by personal message. Thanks!

More info:
http://www.gammon.com.au/electronics

sbright33

The code is similar!  Some of the autonomous code I have written for Arduino actually runs better on a ChipKit because it's faster.  You can change the loop delay and everything else works.
If you fall... I'll be there for you!
-Floor

Skype Brighteyes3333
(262) 696-9619

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy