Go Down

Topic: Unmanned Quad Copter Project (Read 2384 times) previous topic - next topic

Hi all,

I'm currently working on a project where I am making a quadcopter.  This copter only needs to be able to lift off the ground for a few seconds and then set down safely.  I am currently using a Chip Kit Max32 and will be controlling the 4 motors with a motor driver.  What is the easiest way I can program this and set it up to give me my desired results?  Thanks a lot for all your help.

PaulS

Quote
What is the easiest way I can program this and set it up to give me my desired results?

Perhaps your local Ford dealer could help. Why would you ask questions about some non-Arduino board here?

Nick Gammon

Please post technical questions on the forum, not by personal message. Thanks!

More info:
http://www.gammon.com.au/electronics

sbright33

The code is similar!  Some of the autonomous code I have written for Arduino actually runs better on a ChipKit because it's faster.  You can change the loop delay and everything else works.
If you fall... I'll be there for you!
-Floor

Skype Brighteyes3333
(262) 696-9619

Go Up