Go Down

Topic: Sending pulses to a 1531 strobotac stroboscope with external trigger (Read 3918 times) previous topic - next topic

Hey I'm an artist working and know little about physical computing and arduino for that matter. I'm not completely oblivious since I do do a lot of research but I don't know how to proceed with this one so I'm asking for your help please.

I want to control the 1531 strobotac from it's external trigger. It takes a quarter inch phono jack. I need to trigger the strobes inbetween a threshold of about 59-61 hz per sec. I want to be able to control the value in Hz with an EEG device. I was told that maybe I need to get a relay switch because the Arduino may not be fast enough? Can anyone confirm this?
I've attached a youtube link on this guy discussing the external trigger and the data sheet for the 1531 strobotac. Please help this assignment is due on tuesday!

http://www.youtube.com/watch?v=QlFcDh8yc9U
http://www.tequipment.net/assets/1/26/Documents/IET_GR1531AB.pdf

Thanks


Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy