« previous topic   next topic »
Pages: [1]   Go Down
Author Topic: Livolo + arduino  (Read 606 times)
0 Members and 1 Guest are viewing this topic.
Lafriks
Offline Offline
Newbie
*
Karma: 0
Posts: 1
View Profile
« on: December 27, 2013, 06:29:45 pm »
 Bigger Bigger Smaller Smaller Reset Reset
In livolo light switches there are two boards that are connected with 2x8 connector. Would it be possible to connect arduino (maybe even power it) in between main and sensor boards? It's nice that these switches can be controlled remotely but I really want to get feedback on switch state. I'm new to arduino and electronics i'm software developer so I would need an advice if it could be possible or not. If it is - what could be the best way to find out what each connector is used for?
Logged

spch
Offline Offline
Newbie
*
Karma: 1
Posts: 47
View Profile
« Reply #1 on: January 02, 2014, 01:22:15 am »
 Bigger Bigger Smaller Smaller Reset Reset
Hi,

Not sure if it could work, but Livolo has switch state LEDs (blue when off, red when on). You could connect switch's LED output to Arduino (digital input) to detect switch state.
Logged

Pages: [1]   Go Up
« previous topic   next topic »
Jump to: