Go Down

Topic: SAM3X8C custom board (Read 495 times) previous topic - next topic

Owais

Hello everyone,

                              I have recently built a custom board based on SAM3X8C. I can read the chip using SAM-ICE and load a simple led program using Atmel Studiom 6.1. However, the program does not run and once I try to debug the disassembly window shows up instead of the main program. Anyone here who can help me in this matter?

Regards,
Owais.

jstampfl

You might have better luck at "at91.com"

http://www.at91.com/forum/viewforum.php/f,24/sid,65c4cc451cc736b6df7944ef9cc0b9fe/


Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy