Pages: [1]   Go Down
Author Topic: Cheap Current Sensing/Feedback  (Read 144 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Full Member
***
Karma: 1
Posts: 137
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hello,
I have many automated devices in my home via arduino/processing/web/blah blah blah but my biggest issue is not knowing (via arduino) if the actual device is on or not.  I have created a board with a couple ACS712s on it to sense current but it's somewhat of an expensive process.  So my question is, is there an easier way to receive feedback from the lamps/tvs/dc devices/other home crap that are largely controlled by relays so that the arduino can know if it was successful?
Logged

Offline Offline
Full Member
***
Karma: 2
Posts: 136
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

a small relais of 5 volt dc together with a diodebridge and a shunt resistor (calculate it,like for 1 amp it is 5 ohm use a 10 watt type
same with a simple optocoupler
or a coil with some windings used astransformer

something different is a bulboke cicuit with high freq filter.
Logged

Pages: [1]   Go Up
Jump to: