Pages: [1]   Go Down
Author Topic: Debug mode of example/GSMScanNetworks not working  (Read 772 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 5
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Just wondering anyone encounter this problem. I've set debug mode for the example/GSMScanNetworks:

GSM gsmAccess(true);

However, I don't see the AT commands between the Serial Monitor and GSM shield being displayed. Any suggestions? Thanks.
Logged

Offline Offline
Full Member
***
Karma: 1
Posts: 106
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Have you activated Serial.begin()?
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 5
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Yes, it is activated using the Serial Monitor. Messages are being display, but without the AT message between Shield and Uno.
Logged

Madrid (Spain)
Offline Offline
Full Member
***
Karma: 0
Posts: 135
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Without debug mode, does GSMScanNetworks works properly?
Logged

Pages: [1]   Go Up
Jump to: