Go Down

Topic: Debug mode of example/GSMScanNetworks not working (Read 917 times) previous topic - next topic

tseeteck

Just wondering anyone encounter this problem. I've set debug mode for the example/GSMScanNetworks:

GSM gsmAccess(true);

However, I don't see the AT commands between the Serial Monitor and GSM shield being displayed. Any suggestions? Thanks.


tseeteck

Yes, it is activated using the Serial Monitor. Messages are being display, but without the AT message between Shield and Uno.

davidgoth

Without debug mode, does GSMScanNetworks works properly?

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy