Go Down

Topic: Analog audio mixer controllable via MAX/MSP (Read 1 time) previous topic - next topic

antialias

I'm wondering if the following would be possible using Arduino, and if so, what hardware would be required:

Analog audio mixer controllable via MAX/MSP

--ideally would be a matrix mixer (say 4 in and 4 out) where any combination of inputs could be sent to any combination of outputs

--ideally these sends would have gain control or passive attenuation. Simple on/off would be OK too.

-- alternatively one-channel active or passive gain controls or on/off gates would work.

The purpose is to automate with Max a 'no input' analog feedback systems using guitar effects pedals.

Any pointers much appreciated!

antialias

Thanks for your reply! I found the following chips that look useful-- just wondering what Arduino hardware would be necessary for the project:

3 X 3in/2out
http://www.maxim-ic.com/datasheet/index.mvp/id/2046

mic preamp
http://www.maxim-ic.com/datasheet/index.mvp/id/3406

CrossRoads

Just use the SPI library to talk to this one, very simple connection.
3-Wire SPI/QSPI/MICROWIRE-Compatible (MAX4549)


The second one, looks like you need a logic signal to switch between the two inputs.
Can be arduiono driven directly, or the output of a register that the ardiuno writes to.
Designing & building electrical circuits for over 25 years.  Screw Shield for Mega/Due/Uno,  Bobuino with ATMega1284P, & other '328P & '1284P creations & offerings at  my website.

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy