Pages: [1]   Go Down
Author Topic: supplying with higher Ampheres  (Read 240 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

i just want to ask if i can supply the arduino mega board with 5v "23 Amps"? im planning to modify my power supply that i used before in my computer to a regulator that i will use in our project at school.  im a noob i dunno if can supply it with higher amps but i know what current does i just wanna make sure my board will not burn (OCD).
Logged

The Netherlands
Offline Offline
Edison Member
*
Karma: 50
Posts: 1713
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

The current rating of that supply, tells you what it CAN deliver.
That means your device (an Arduino) will not take more than needed.
Of course you need to wire it correct and double check for that before turning on that power.
And because it is severe overkill, the supply will be inefficient.
If you want to be sure, use a fuse in the power line.
The Arduino has an on board fuse (i don't know it's rating by heart), but if you use this supply for other peripherals too, a fuse is a good idea.
It will protect your devices, and the wires from melting (sending 23 A through a wire requires thick wires, unusable for your Arduino or breadboard).
Logged

Have a look at "blink without delay".
Did you connect the grounds ?
Je kunt hier ook in het Nederlands terecht: http://arduino.cc/forum/index.php/board,77.0.html

Pages: [1]   Go Up
Jump to: