Pages: [1]   Go Down
Author Topic: Helpme please with my on board computer proyect.  (Read 146 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 7
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hello I am an electronics technician and in my work I have scheduled different types of plc and numerical control programming on different platforms but this of me consisting Aduino this work ....

My project consists of a tablet connected via bluetooth to an Arduino MEGA ...
I want to give yourself the tablet monitor 3 measures and handle some outlets ....

1) Temperature (with DHT11).
2) Distance (with US-020).
3) The state of a limit switch (it's just a HIGH or LOW)

Here is my problem .... I have read "individually" (so three different sketch) each of these measurements and send them to my tablet, the problem is not how to send the three together and then "desenpaquetarlas" to separate temperature distance on one side and is on the other end of stroke condition by another ...

I guess this is done by defining bits but can not find any examples ...
From already thank you very much ...

Greetings friends!
Logged

Prague, Czech Republic
Offline Offline
Newbie
*
Karma: 1
Posts: 7
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Please post the code how you send the individual measures, it's hard to tell without.

Generally you can either
Logged

Pages: [1]   Go Up
Jump to: