Pages: [1]   Go Down
Author Topic: help with vrbot!  (Read 908 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Newbie
*
Karma: 0
Posts: 2
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

hi! i just recieved my vrbot today and i was trying to test it out, but the vrbot gui keeps saying "could not detect device connected to port COM3" and i'm thinking it's because i didnt short pins 2 and 3 like it says in the directions.. but what the heck does it mean by having to short pins 2 and 3? does it mean to connect those two pins together??

much help is needed and appreciated!!!!!!!!! :-[
Logged

0
Offline Offline
Newbie
*
Karma: 0
Posts: 2
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

YES! i'm sry.. i'm new to all this

um... vrbot and arduino hardware
i'm using vrbot gui 1.1.5 and arduino 0021 software
running windows 7

what i did was i set up my mic and plugged in my connections from my vrbot to my arduino.. correctly i know cuz ive been staring at it

i'm kind of confused about this "normal and bridge" mode thing and how to set it up?

the directions say "in order to start in normal mode you have to short pin 2 and 3 and then turn the board on." for bridge , short pin 2 and 4...
but theres no way i can turn the board on and off! theres only a reset button smiley-sad i have to unplug and plug back in.

i think this problem is the reason why the rvbot gui couldnt detect the device????
Logged

0
Offline Offline
Tesla Member
***
Karma: 141
Posts: 9541
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

What is an "rvbot"?
Logged

Consider the daffodil. And while you're doing that, I'll be over here, looking through your stuff.   smiley-cool

Pages: [1]   Go Up
Jump to: