Go Down

Topic: servo and arduino (newbie) (Read 588 times) previous topic - next topic



I am connecting one servo to Arduino , very simple (5v, Gng, port 9)
and using the Sweep example.

but I am not able to have the delay or any type of control...

I am receiving the following mesage:
"problem uploading to board"
and in red underneath it says " avrdude: stk500_getsync(): not in sync: resp=0xe0
avrdude: stk500_recv(): programmer is not responding"

I know that it's problably really simple to solve it , but I am really new to that.

thanks a lot in advance



VIVAAA Thanks a  lot :D

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131