Go Down

Topic: help to build an ir transmitter (Read 2151 times) previous topic - next topic

arvindpandi6

guys,
i am new to arduino,
i working with tsop and ir leds to build a remote
i have wrote a basic code to transmit a nec code in hex"1FE50AF"
the code i wrote is
#include <CppList.h>
#include <IRremote.h>
#include <IRremoteInt.h>
#include <IRremote.h>
IRsend irsend;
int RECV_PIN = 11;
IRrecv irrecv(RECV_PIN);
decode_results results;
void setup()
{
  Serial.begin(9600);
  irrecv.enableIRIn();
}
void loop()
{

  irsend.sendNEC(0x1FE50AFUL,32);
  Serial.print("Sent NEC ");
 
  irrecv.decode(&results) ;
 
    Serial.println(results.value);
    irrecv.resume(); // Receive the next value
 

}
my leds is illuminating but i am not receiveing in tsop..can you guys help me

AnalysIR

Couple of things

You need to place your code in code tags (the # button on top when editing) otherwise too hard to read your code.

You cannot send and receive at the same time using IRremote - as it doesnt make sense. You need to have 2 different Arduino systems to test one a sender and one a receiver.

Normally people use an existing remote control to test receiving and a TV to test sending - thus no need for 2 Arduinos.
Visit our Blog about Infrared Remote Control >>>> http://www.AnalysIR.com/blog/  Twitter: @AnalysIR
First Read this PDF=> 10 common pitfalls with Infrared Remote Control >>> http://bit.ly/1cvd0at

Drew Davis

This should help you out...

https://learn.sparkfun.com/tutorials/ir-control-kit-hookup-guide

Go Up