Go Down

Topic: Linksys + dd-wrt + arduino (Read 10874 times) previous topic - next topic

Igor R


  • http://www.ostrosoft.com/oswinsck.asp
  • http://www.codeproject.com/KB/IP/MinimalisticTelnet.aspx

You can download an example excel from my blog http://real2electronics.blogspot.com/2009/10/linksys-arduino.html



Dec 17, 2010, 10:21 am Last Edit: Dec 17, 2010, 10:30 am by Erac Reason: 1
Hi Igor,

My router firmware is White Russian 0.9 ( open WRT) , and my problem now is[glow] I can't access Telnet[/glow] so I can transfer the sensor feedback to visual basic..

Any suggestions? Or Will I have to change my firmware to dd-wrt?

Regards :-[


would this work if lets say i would like to upload a sketch to a remotely located arduino?

Igor R

I suppuse that you can activate to load telnet service again when the router starts..... I'm not a linux expert, but I can't believe that you can't activate it...
(here you can see how the telnet service is disable)

If you don't have telnet, I imagine that you have ssh, which it's more safe. I've never checked if there are free ActiveX ssh clients.....



Hi Igor,

Do you know the code in Visual Basic 6.0 or Excell that will get the data via SSH? When I try Winsock the access is denied, maybe because it gets data via telnet? which is problematic for my firmware

Regards :-/

Igor R

Dec 19, 2010, 12:56 am Last Edit: Dec 19, 2010, 12:57 am by igorreal Reason: 1

Look at this method..... it´s nice. You can download ser2net

And use a virtual serial port:




I've not seen this disassembled but it is Arm based and 99 dollars.
If it was designed by man it can be repaired by man.

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131