Pages: [1]   Go Down
Author Topic: GLCD not showing any characters  (Read 531 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Jr. Member
**
Karma: 0
Posts: 50
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hello all,
I am using a Duemilanove and 128 *64 GLCD but I am unable to start my GLCD - bought from sparkfun. I have the backlight on after the connections but I am not getting any characters printed on it at all. This is my GLCD: http://www.sparkfun.com/products/710
I have made connections as shown for Panel A here: http://www.arduino.cc/playground/Code/GLCDks0108
Despite the connections and hour-long efforts, nothing at all. I have tried several libraries like KS0108 and GLCD library. But so far, i m unsuccessful.

Please help me out here folks.
Logged

Dallas, TX USA
Offline Offline
Faraday Member
**
Karma: 70
Posts: 2763
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Are you running the newest ks0108 library?
The GLCD V3 library that is beta.
That library has a diagnostic sketch that sends information
to the serial port that is helpful to see what is going on.
If you can run that sketch and post the output here so I can
take a look at it.

--- bill
Logged

Pages: [1]   Go Up
Jump to: