Go Down

Topic: Seeed studio Motor Shield V1.0 (Read 1 time) previous topic - next topic


I am doing a science olympiad project called Robo-Cross and I have the Seeed Studio motor shield V1.0 (http://www.seeedstudio.com/wiki/Motor_Shield_V1.0). This was given to me and I would really like to use it for this project, but nowhere can I find if there is a way to take inputs while using this shield. It looks like it takes some of the I/O for the DC motor terminals and all the rest for servo outputs. If anyone could find a way to wire in inputs, that would be great.


datasheet is found here http://www.seeedstudio.com/wiki/Motor_Shield_V1.0
Pins 8..13 used.
Other digital and analog pins available  in sockets


Yes, but didn't it also say that those grove pins were for servo output, not for inputs?


yes, you can use small servos (not recommended), but as schematic shows, there are two i/o pins to be reached in each of them
..(in addition to 5V and GND)


Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131