Loading...
« previous topic   next topic »
Pages: [1]   Go Down
Author Topic: How do i get my sd card reader to work?  (Read 268 times)
0 Members and 1 Guest are viewing this topic.
ryanteck
0
Offline Offline
Full Member
***
Karma: 0
Posts: 144
Arduino rocks
View Profile
« on: January 10, 2011, 01:05:06 pm »
 Bigger Bigger Smaller Smaller Reset Reset
Hey guys
i have the following home made sd card reader setup
http://www.arduino.cc/cgi-bin/yabb2/YaBB.pl?num=1206874649
the only thing is that the libarys dont seem to work for it.
any help?
Logged

ryanteck
0
Offline Offline
Full Member
***
Karma: 0
Posts: 144
Arduino rocks
View Profile
« Reply #1 on: January 10, 2011, 02:30:44 pm »
 Bigger Bigger Smaller Smaller Reset Reset
There is only bits and peices of code on the thread. Im looking to see if anyone else had made one and has the code
Logged

Grumpy_Mike
Manchester (England England)
Offline Offline
Brattain Member
*****
Karma: 277
Posts: 25566
Solder is electric glue
View Profile
WWW
« Reply #2 on: January 10, 2011, 02:38:14 pm »
 Bigger Bigger Smaller Smaller Reset Reset
Using passive components like the potential divider for converting a 5V signal to a 3v3 one is not a technique that works on Ada's wave shield used to use this technique but she changed it to using TTL voltage converters for better reliability.
Quote
There is only bits and peices of code on the thread
If you are only using bits and pieces of code how do you expect it to work? You need to post what you have tried.
Logged

Pages: [1]   Go Up
Print
« previous topic   next topic »
 
Jump to: