Pages: 1 ... 9 10 [11]   Go Down
Author Topic: works: MIDI-IN: code + schematics  (Read 44063 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Newbie
*
Karma: 0
Posts: 3
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Yep, I did try your schematic, no luck.  My experience was the same as Charbot.  

For those planning on building this, order a few of both optocouplers to be safe. smiley-wink

Logged

0
Offline Offline
Newbie
*
Karma: 0
Posts: 3
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi, I just recieved for Xmas my Arduino Mega, and I wish to control circuit bent devices (toy keyboards, speak and spell, DIY filters...) via Midi with Arduino.

Any help would be appreciated !

Question : did anyone tried the midi library for Arduino ?

Thanks
Logged

0
Offline Offline
Newbie
*
Karma: 0
Posts: 3
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Here is the official midi schematic for inputs, outputs and through ports :
http://www.midi.org/techspecs/electrispec.php

The triangle amps followed by a small ring are inverters, like the 4049, used for buffering the signal.
http://en.wikipedia.org/wiki/Inverter_%28logic_gate%29
Logged

0
Offline Offline
Newbie
*
Karma: 0
Posts: 3
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi !
I hacked my old dead Atari 1024stf with a handsaw and a dremel to get the midi in and out pcb with optocoupler, inverters and 556 timer.
(Off topic : do you know what the 556 do in midi out messages ? Midi clock ?)

It works great as a midi input optocoupler !
Logged

Pages: 1 ... 9 10 [11]   Go Up
Jump to: