Pages: 1 2 [3]   Go Down
Author Topic: mjkdz I2C - modify lcd constructor  (Read 1320 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 8
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Yes, I can make the pixels dissapear.
Logged

NSW Australia
Offline Offline
Faraday Member
**
Karma: 78
Posts: 3189
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Yes, I can make the pixels disappear.

Following the procedure bperrybap detailed, so does anything show up on the "guesser" sketch then?
Logged

Offline Offline
Jr. Member
**
Karma: 1
Posts: 91
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I just checked mine, and with only power and not the SDA SCL connected i get the top row with just squares, i know you took a picture but it didn't show the full trace between the pins on the arduino and the i2c on the lcd, is it possible those two cables are backwards?  A4 to SDA and A5 to scl
Logged

NSW Australia
Offline Offline
Faraday Member
**
Karma: 78
Posts: 3189
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Is it possible those two cables are backwards?  A4 to SDA and A5 to scl

The i2cscanner and "guesser" scripts are finding the I2C address and activating the backlight.
Logged

Pages: 1 2 [3]   Go Up
Jump to: