Pages: [1]   Go Down
Author Topic: Overcurrent protection  (Read 1564 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Full Member
Karma: 0
Posts: 203
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I slipped with a probe, shorted a power to ground, and burned a trace off my protoshield (sparkfun variant) today. Seems the first 7mm or so of trace from the +5v pin is the fusible link in the design.

I'm a bit surprised. I was running on USB power and I thought those were limited to 500mA. Perhaps PCB traces don't handle as much current as I thought.

So, for people making protoshields, I'm glad the shield failed before the Arduino, but...

It would be nice to have a resettable fuse to limit the current to something under the trace failure current. I looked at polyfuses but wasn't able to find one of an appropriate current limit that didn't have an unacceptably high resistance.

An alternative would be to beef up the +5 traces so they could handle the 1 amp or so that the onboard regulator makes, and hope the USB won't make more. It is currently a very narrow trace so it can sneak through the hole field. A wider trace would have to go around, but could be serveral times wider... heck, have both.
« Last Edit: March 13, 2007, 02:49:00 pm by jims » Logged

 Bigger Bigger  Smaller Smaller  Reset Reset


fyi the Arduino regulator is a 78M05, good for 500ma. It does have short circuit protection/current limiting. but that won't help with burnt traces...
But hey, what would building things in electronics be without the occasional smell of burnt PCB? smiley


Pages: [1]   Go Up
Jump to: