Go Down

Topic: RF Module interfacing with Arduino leonardo (Read 4 times) previous topic - next topic

neeraj786

i am interfacing RF(433Mhz) module with Arduino and facing a problem when Tx is not turned On then Rx receiving  garbage Value that are showing on Serial terminal of arduino. how can we avoid these Garbage Value when Tx is not turned ON Help plz..

NI$HANT

your Rx is floating get it balanced. check the connections!
"Real Men can Accomplish  Anything"
- <a href="http://www.winacro.com">  <b><font color="red">Website</font></b> </a> 
- skype : nishants5  

ਫ਼ਤੇਹ ਕਰੁਂ!

krishnapatil

If all your connections are right and still you get garbage values then , you may have pair these modules with HT12E and HT12D. Because 433 Mhz ASK receiver has very wide bandwidth of 2MHz which will pick up lot of noise .
Krishna Patil

Go Up
 

Quick Reply

With Quick-Reply you can write a post when viewing a topic without loading a new page. You can still use bulletin board code and smileys as you would in a normal post.

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.
Name:
Email:

shortcuts: alt+s submit/post or alt+p preview