Pages: [1]   Go Down
Author Topic: Prototyping Board - single side available  (Read 557 times)
0 Members and 1 Guest are viewing this topic.
Earth, Sol
Offline Offline
Newbie
*
Karma: 0
Posts: 3
Arduino may rock
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hello
I have modified "Prototyping Board" to be suitable for making single side PCB. Uses only ~4 jumper wires.

How can to upload the new version to arduino's PmWiki?
Logged

Earth, Sol
Offline Offline
Newbie
*
Karma: 0
Posts: 3
Arduino may rock
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

(The original is http://www.arduino.cc/playground/Main/PrototypingBoard)
Logged

Forum Administrator
Cambridge, MA
Offline Offline
Faraday Member
*****
Karma: 9
Posts: 3538
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

You can create an account here: http://www.arduino.cc/playground/Main/LoginForm
Logged

Earth, Sol
Offline Offline
Newbie
*
Karma: 0
Posts: 3
Arduino may rock
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I have already registered. However I was not able to find out how to upload the modified Eagle files. (PmWiki documentation says that uploads are disable by default. I have read "formatting suggestions", "WikiSandBox training", "Basic Editing".)
I discovered (thanks to http://www.pmwiki.org/wiki/PmWiki/Uploads) to use
http://www.arduino.cc/playground/Main/PrototypingBoard?action=upload

Uploaded. Thanks a lot.
Logged

Pages: [1]   Go Up
Jump to: